Carburetor #26 For Kohler K241, K301, M10, M12 Engines

I purchased my Cub Cadet carb and fuel sediment bowl. Received them within 3 days and installed. I had a technical mental problem while trying to set the carb/ gov linkage. I called and left a message after hours yesterday and received a return phone call a little while ago asking for assistance and thoughts concerning the issue. Problem was after install the cable the carb and gov would not move. After some brief discussion and the probable cause being "I may have just over looked something". Immediately went back out to take a look at it after a good nights rest and reassurance from you. THe results was embarrassing. Being a disabled vet with minimal use of my hands and arms I had to use wire to wrap around the clutch/ brake/ safety pedal to hold it down. Since I was not starting the tractor sitting at the seat and looking at the control upside down I had inadvertently had the throttle lever all the way in the down position (slow) thinking it was the fast position. This was causing the cable to bind since there could be no movement because the butterfly arm was already pushed up against the adjustment screw. As soon as I realized this I loosened the screw holding the cable in place and moved the throttle linkage and lever to the "fast" position, secured the cable and low and behold after priming the old cubby fired right up. It is very great to see and know of a company who not only sells parts but understands the functionality of the equipment/ engines the parts are attached to. Once again, a huge THANK YOU to you guys. That is stand up customer service. If you do have a way to post this feel free to do so. JR Dibble ~ Alabama

I installed this on a 1979 Simplicity 7010 lawn tractor. It has been sitting since 2005. This will be hard to believe, but the tractor started in less than 2 minutes!!! Mows and idles nicely, for an old hoss! Don't know why I waited so long.......

Good carb. Pain in the butt to tighten down. Other then that it runs great

So I called earlier and left a message. I actually got a phone call back from Norman. What a surprise now a days. He walked me through my issue and 1 minute later my carb was ordered. All I can say is that is what service should be. I will only be dealing with them for now on. Thanks for all the help norman

This is on a Deere 212 with a 12hp K301. Works great right out of the box. Made the high-speed and low-speed adjustments and runs great. Like others have mentioned, had to trim a little bit off the throttle linkage on top to clear the air cleaner but other than that runs perfect.

The new carburetor worked perfectly out of the box. I did have to grind down the additional length on the throttle arm that would be where a cable would attach. Other than that it was perfect. Tractor fired up right away, and runs better now than ever.

It fit well and works. Only modification was trimming the throttle lever

I had previos;y puchased one E bay, after modifying it to hook up to linksgr , my wheelhorse was no better than before. Bought this one an exact fit, trn minutes and running great.. Never going "el-cheapo " again.

Fit perfectly