Ignition Parts

iSaveTractors Brand Points and Condenser Set for Onan CCK Engines

iSaveTractors Rubber Grommet for the points cover on your Kohler K Series Engines. Will fit all Kohler K Series Engines that use an ignition point system...

iSaveTractors brand ignition coil for old Cast Iron Briggs and Stratton Engines. These are for the Cast Iron Horizontal Shaft Briggs Engines from 7HP trhu 16HP that used external breaker points. Fits Briggs and Stratton Model...

Aftermarket ignition coil for Kohler K482, K532, K582 Engines. Also will work for Kohler KT17 and KT19 Engines. 4.5 ohm primary winding resistance Copper windings Mounting Holes are 1 1/4" apart. Replaces Kohler 277375S, 271688,...

iSaveTractors brand solid state ignition coil for Kohler Magnum Single Cylinder Engines. Will fit Kohler Engine Models: M8, M10, M12, M14, M16 Replaces:  Kohler 4758403s Kohler 4758401

Spark plug for Kohler MV16, MV18, M18, MV20, M20, KT17, KT19 Twin Engines. 16HP through 20 HP. Champion RV17YC Spark Plug

iSaveTractors ignition coil for Kohler Magnum Twin Engines including the Kohler MV16, M18, MV18, M20, MV20. This coil has the proper primary winding resistance to operate with older flywheels with weaker magnets. This coil went through an entire year of...

New iSaveTractors ignition coils for Kohler K141, K161, K181, K241, and K301 Engines equipped with a magneto ignition system. This is our new improved version where you don't need to modify any of the wires. Replaces: Kohler 4775520s Kohler...

Chamption J8C Spark Plug Recommended Spark Plug for Kohler K141, K161, K181 Engines

Champion H10C Spark Plug For Kohler K Series Engines K241, K301, K321, K341, K361, K482, K532, K582 10HP through 23 HP Engines.

iSaveTractors brand Points Push-rod for Kohler K Series Engines   Replaces: Kohler Part: 4741104-S  

Starter Solenoid  5/16" Posts for Starter circuit. 1/4" Posts for low amp activation circuit. These solenoids have 2 small terminals. One terminal is for the 12v activation circuit from your key switch, and the other is for ground. Terminals are...