Description
- 20 Piece Gasket Set including Oil Seals
- Intake and Exhaust Valves*
- Piston
- Piston Rings
- Wrist Pin and Clips
- Connecting Rod
- Carburetor
- Carburetor Ball Joint Throttle Linkage
- Additional style carburetor choke for old style engines
- Points w/mounting bracket and Condenser
- Ignition Coil with mounting bracket
- Crankshaft Bearings
- iSaveTractors Sticker
*Note: The exhaust valve on K321 come in 2 variations. Older style engines came with an exhaust valve that is smaller than the intake valve. The valve head measures 1 1/8" Diameter. Newer style engines came with the exhaust valve the same size as the intake valve and measures 1 3/8".
Videos
-
How to Restore Your Vintage Garden Tractor Ep. 3: Kohler K Engine Removal and disassembly
In this video I show you how to remove a Kohler K Series Engin...
-
How to Restore Your Vintage Garden Tractor Ep. 4: Kohler K Engine Disassembly part 2
In this video I continue where I left off in episode 3. I sho...
-
How to Restore Your Vintage Garden Tractor Ep. 5: Measuring the Kohler K Engine
In this video I show you how to Measure the Crankshaft, Cylind...
-
How to Restore Your Vintage Garden Tractor: Ep. 6 Kohler K Engine Reconditioning & Reassembly
In this video I completely reassemble a Kohler K301 12 HP Engi...
31 Reviews
-
rebuild kit carburetor
everything in the rebuild kit was great no problems except the carburetor the float was set to low and would flood and I'm still trying to get it adjusted correctly also I changed the float shaft and the choke plate did not fit in the carb correctly I had to ream out the screw holes one way to get it to fully close and open.
-
Overhaul kit for 321
Thank you
-
Just what I needed
My go to for tractor parts!
-
Best rebuild kit
High quality gaskets, fit and finish was perfect
-
K321 rebuild kit
Everything I needed ,everything fit perfect. This is a great kit for a complete rebuild on your K321 engine. Came in a well protected box and arrived on time .No complaints ,well satisfied.
-
Engine rebuild kit
This kit is the most complete kit I could find and everything fit perfectly. Make sure to adjust ring end gap. The only extra item that I needed was the small points cover wire grommet.
-
I'm very impressed with the way it runs.
Hey just wanted to say I purchased a k321 engine rebuild kit from you about a year ago. I have the engine back together and running. It runs very good and starts up easily. I'm very impressed with the way it runs. Thank you for supplying the parts. It runs great!
-
Parts arrived in a timely manner but the packaging was poor the piston and rings where loosely packaged and the center ring was broken during shipment didn't get the block and crank back from machine shop but everything else seams to be good
Parts need to be packaged a little better to keep from damage
-
Very high quality
Just got done with a complete overhaul on my k321, bored .020 over and crank ground .010 under. The machinist said that the parts were good quality, the exhaust valve non magnetic, connecting rod bore round unlike most aftermarket and piston was good also. It fired right up after assembly and I mowed for 2 hours with no problems. Everything is looking good. Thanks Norman!