Carburetor for Kohler MV16, M17, M18, MV18, M20, MV20, KT17, KT18, KT19

Carburetor replacement Bolt of this carburetor on and it started right up

Carburetor replacement Bolt of this carburetor on and it started right up

I finished adjusting the low speed and high speed screws (engine running) and went for a drive around the neighborhood. The engine run wonderfully, it also helped adding some fresh gas to the tank. Anyway, I originally installed the new carb with the original throttle blade and shaft due to linkage fitment. Bad idea, engine barely ran, engine seemed to have an intake vaccum leak. Next day pulled out the old throttle blade/shaft, modified (drill out hole) the new throttle shaft top butterfly for a linkage bushing. Re-installed the carb, started up the engine, adjusted low/high speed screws, and the result was stable engine operation. Bottomline, excellent product. The installation videos inspired confidence in terms of product and installation.

Response and support were very good. Can't say if product was competetively priced. Product appeared to be of quality.

Perfect fit but had to thread two holes for breather mount

Bought this for my 87 wheel horse M-18. Runs like a champ again. A +

Great service and the part fit perfectly, a one to one swap, and the shipping was super quick.

Excellent replacement. Had to swap the throttle shaft and plate from the old carb to fit the linkage but it fit perfectly, and the machine starts and runs better than ever.

I was surprised because I had purchased a cheaper version and it did not work at all. But this is the real deal