Carburetor for Kohler MV16, M17, M18, MV18, M20, MV20, KT17, KT18, KT19

Look forward to shop with you all in the near future.

Worked great,had to make a spacer for air cleaner but otherwise easy install

Nice replicated carb. Much nicer than the Chinese Amazon specimens. This one comes with the extra choke shaft, and instructions on how to swap them, which is exactly what I needed. My original carb was a Walbro fixed jet. This one is an adjustable jet and the settings are very touchy. Took some time, and a lot of cranking, until I found the sweet spot where she would run. Still needs tweaking, but its running now, which is what my goal was for replacing the carb. Throttle lever needs some work. Not an exact fit. May try swapping it from the old carb.

Carburetor replacement Bolt of this carburetor on and it started right up

Carburetor replacement Bolt of this carburetor on and it started right up

I finished adjusting the low speed and high speed screws (engine running) and went for a drive around the neighborhood. The engine run wonderfully, it also helped adding some fresh gas to the tank. Anyway, I originally installed the new carb with the original throttle blade and shaft due to linkage fitment. Bad idea, engine barely ran, engine seemed to have an intake vaccum leak. Next day pulled out the old throttle blade/shaft, modified (drill out hole) the new throttle shaft top butterfly for a linkage bushing. Re-installed the carb, started up the engine, adjusted low/high speed screws, and the result was stable engine operation. Bottomline, excellent product. The installation videos inspired confidence in terms of product and installation.

Response and support were very good. Can't say if product was competetively priced. Product appeared to be of quality.

Perfect fit but had to thread two holes for breather mount

Bought this for my 87 wheel horse M-18. Runs like a champ again. A +