iSaveTractors
Carburetor Bundle Pack for K321, K341, K361, M14, and M16 Engines
- SKU:
- CAR01021
- UPC:
- 8809093342866
Description
This carburetor is an aftermarket reproduction of the Kohler #30 carburetor. It has a 1.2" Throttle Bore and a 1.0" Venturi. It also will replace the Walbro WHG #60 and WHG #64 Carburetor.
Our Carburetor Bundle includes everything you need to overhaul your old engine's fuel system:
- Kohler #30 Style Carburetor with Choke Lever Style 2 installed
- Throttle Linkage
- 2 Feet of 1/4" ID, 1/2" OD Fuel Line
- 6 Hose Clamps
- Carburetor Intake Gasket
- Additional Choke Lever for Older Style Kohler K Engines (Choke Lever Style 3)
- 90 Degree Fuel Fitting
- Inline Fuel Filter
- Inline Fuel Shut Off Valve
- Instructions
59 Reviews
-
Excellent product. Works well right out of the box.
Installed this on a 1971 John Deere 140 H3. Fits perfectly, works perfectly. I didn’t even have to adjust the idle/high speed screws. The only thing I needed to change was the choke lever, as the one it comes with is backwards for the JD140. Luckily it comes with the correct lever and is very easy to swap out. 10/10 would recommend.
-
K341 Carb Bundle
Sweet package of carb goodness. Every part mated perfectly. No adjustments required.
-
Carburetor
Nice product. Well made. Bolted right on and ran great with only minor tuning. Nice to have the new gaskets, fuel line, filter, etc. to go with it. Would buy again!
-
carb bundle
worked perfectly . very easy install
-
Exactly what I needed along with all the gaskets and fittings
Had to do one minor revision
-
End result is fantastic! But not without installation issues
Had to tap threads deeper for fuel fitting to fit. In doing so, removed the bowl to remove thread cutting chips and found brass float soldering flux debris flaked off in the bowl. Float was way out of adjustment. Had to run tap deeper in air cleaner screen holes. Had to enlarge hole in choke arm for the actuating wire. Still a great value and runs fantastic!
-
Carburetor for a K341
Bolted right up had to adjust it a little and also had to drill chocK lever out just a bit bigger. Application was a John Deere 300 l&g tractor. Runs great now. Will definitely buy more products in the future from IST.
-
Carburetor bundle
My 2nd review for this product and after some help from norman tractor is running great. Just remember to tighten the fuel inlet elbow on the carb, silly me didn't do that which caused a leak thanks
-
Carb bundle for my gravely 1987 16hp tractor
I got exactly what I ordered. I ordered the wrong carb. It bolted right up then the fuel linkage did not fit so I used the old carb parts. Same deal with the chock. Now it runs rough if at all. These problems are my own fault for not asking for a little coaching on what =should have been a simple bolt on.