Carburetor Bundle Pack for K321, K341, K361, M14, and M16 Engines
This carburetor is an aftermarket reproduction of the Kohler #30 carburetor. It has a 1.2" Throttle Bore and a 1.0" Venturi. It also will replace the Walbro WHG #60 and WHG #64 Carburetor.
Our Carburetor Bundle includes everything you need to overhaul your old engine's fuel system:
- Kohler #30 Style Carburetor with Choke Lever Style 2 installed
- Throttle Linkage
- 2 Feet of 1/4" ID, 1/2" OD Fuel Line
- 6 Hose Clamps
- Carburetor Intake Gasket
- Additional Choke Lever for Older Style Kohler K Engines (Choke Lever Style 3)
- 90 Degree Fuel Fitting
- Inline Fuel Filter
- Inline Fuel Shut Off Valve
Had to tap threads deeper for fuel fitting to fit. In doing so, removed the bowl to remove thread cutting chips and found brass float soldering flux debris flaked off in the bowl. Float was way out of adjustment. Had to run tap deeper in air cleaner screen holes. Had to enlarge hole in choke arm for the actuating wire. Still a great value and runs fantastic!
Bolted right up had to adjust it a little and also had to drill chocK lever out just a bit bigger. Application was a John Deere 300 l&g tractor. Runs great now. Will definitely buy more products in the future from IST.
My 2nd review for this product and after some help from norman tractor is running great. Just remember to tighten the fuel inlet elbow on the carb, silly me didn't do that which caused a leak thanks
I got exactly what I ordered. I ordered the wrong carb. It bolted right up then the fuel linkage did not fit so I used the old carb parts. Same deal with the chock. Now it runs rough if at all. These problems are my own fault for not asking for a little coaching on what =should have been a simple bolt on.
Fitment was a little tighter then original but still bolted right up and came with everything you need to do the job. Parts appear to be good quality
Easy install,instructions great
My old Cub Cadet 147 would leak gas when parked. The existing carb was a Walbro and the needle and seat were not replaceable. This new carb and the provided choke shaft fixed the problem with the old carb. Runs good!
Put on and fired right up,no adjustment needed. thanks for great part.
This was a direct fit carburetor replacement for my Snapper 1600 (Massey Ferguson 16xx). This solved my power and operability issues with my tractor and got me back up and running. Highly recommended and the carburetor is of very high quality.