Kohler K341 / M16

Kohler OEM Rubber Grommet for the points cover on your Kohler K Series Engines. Will fit all Kohler K Series Engines that use an ignition point system including: K90 K91 K140 K141 K160 K161 K181 K241 K301 K321 K341 K361  

Old Style Needle bearing set for the Balance Gears in your Kohler K Engine.  Replaces Part Number:  236506S  These style needle bearings were used in engines with serial number 9641310 and PRIOR * The best way to determine if your...

This is a new aftermarket gasket for your carburetor. This gasket goes in between the intake of your engine and the throttle side of your carburetor.   This gasket is about 1/4" thick and is designed to keep the heat from the engine away from your...

Wire this switch into your electric PTO and starter circuit to allow you to safely activate your electric PTO. This switch will allow you to turn on your electric pto when your tractor is running, but make it so your tractor cannot be started if the PTO...

These are High Quality steel shim spacers for your Kohler K and M series Engines. Correct your end play in your camshaft and balance gears with these shims.   Shims are .005" thick    These will fit the following Kohler...

High quality spark plug cable kit for your small engine equipped with a battery ignition system. Includes: 7mm Low resistance Ignition Cable  Spark Plug Boot and Connector Connector for Ignition Coil already installed Cable is 24" long and...

Ignition Key switch for Battery Ignition Kohler K and Magnum Series Engines   This is a 5 Terminal, 3 Position Ignition Switch. Works for all Vintage Garden Tractors and Kohler K Series and Magnum Engines that use a Magneto Ignition...

This is a new high quality aftermarket Voltage Regulator for your Kohler K Series Engine that is equipped with the Delco Starter Generator for 12 volt systems It has 4 Terminals and is grounded by the body mounts. The 4 terminals...

iSaveTractors Valve Guide for Kohler K241, K301, K321, K341, K482, K532, and K582 Engines. Will also Fit M10, M12, M14, M16 Magnum Series Engines. Specs: ID: 0.309" OD: 0.625" Length: 2.129" Replaces: Kohler:...

This is a Fuel Tank Fuel Fitting for Vintage Garden Tractors with Steel Fuel Tanks.    This fitting is threaded for 1/8" NPT and has a shut off feature and a mesh screen. The hose barb will fit 1/4" ID fuel lines.   Great for your...

Breather Cover Gaskets for Kohler K Series Engines K241, K301, K321, K341 Engines Replaces Kohler: 235048, 235048S 275144, 275144S

Oil Pan Gasket for Kohler K241, K301, K321, K341 Engines. Will also fit M10, M12, M14, M16 with wide base engine block. This gasket is for wide base engine blocks Replaces Kohler: 235057 235057S