Kohler K341 / M16

  iSaveTractors Long Valve Spring for Kohler K241, K301, K321, K341, K482, K532, K582, M10, M12, M14, and M16 engine models. This spring has a spring height of 1.850". This valve spring is used for valves that do not use a valve rotator. Suitable...

  iSaveTractors brand aftermarket gasket for the breaker points cover for Kohler K series engines. This gasket fits all Kohler K series engines that use a breaker point ignition system.  Kohler K91, K141, K161, K181, K241, K301, K321, K341,...

  iSaveTractors Rubber Grommet for the points cover on your Kohler K Series Engines. Will fit all Kohler K Series Engines that use an ignition point system...

  Carburetor Gasket set for the following engine models: K241, K301, K321, K341, K361, K482, K532, K582 M18, MV18, M20, MV20 KT17, KT19 Includes 3 different styles of Air Filter Housing Gasket, and 1 Intake Mounting Gasket.  

  iSaveTractors brand solid state ignition coil for Kohler Magnum Single Cylinder Engines. Will fit Kohler Engine Models: M8, M10, M12, M14, M16 Replaces:  Kohler 4758403s Kohler 4758401

  Adjustable Throttle Linkage for Kohler K Series Carburetors with Ball Joint on the throttle arm. 3/16" e-clip included. Replaces: Kohler 45 208 03-S  Kohler 235277-S

  Aftermarket Plastic Throttle/Governor Bushing for Kohler K Series Carburetors. Replaces Kohler Part: 2515811S

  Kohler OEM Governor Cross Shaft Kit Kohler Part Number A-235256-S Fits Kohler K241, K301, K321, K341, K361, M10, M12, M14, M16 Engines.

iSaveTractors brand Points Push-rod for Kohler K Series Engines   Replaces: Kohler Part: 4741104-S  

  Starter Solenoid  5/16" Posts for Starter circuit. 1/4" Posts for low amp activation circuit. These solenoids have 2 small terminals. One terminal is for the 12v activation circuit from your key switch, and the other is for ground...

  Kohler OEM 15 Amp Stator Will fit Kohler K141, K161, K181, K241, K301, K321, K341, K361, M14, M16, M18, M20 and many others Kohler Part 237878-S Dimensions: 5 1/2" OD

This is a new aftermarket gasket for your carburetor. This gasket goes in between the intake of your engine and the throttle side of your carburetor.   This gasket is about 1/4" thick and is designed to keep the heat from the engine away from...